Heavy duty hot dipped galvanized washer.
Fits 1 5/8" outside diameter pipe. Packaged in set of 4.
Reinforces inside corners.
Use to connect roll in and stationary dock sections.
8" cleat with large tie off area. Mounts with two screws (Not Included).
Reinforces and supports frame.
Fits 1 5/8" outside diameter pipe.
Powder coated steel reinforces dock frame corners.
Screw mounting centers.
Brass. For 1" diameter drains.
Cam-action neoprene plugs. Snap shut to form a leakproof stopper for Livewells or Baitwells.
For 1" diameter drains.
For OMC, Johnson, and Evinrude. Features ultrasonicly welded acetal. 3/8" Barb.
Panel-mounted rocker switch for use with pump that draws 10 amps or less. 1/4" spade terminals. 6 Volt through 32 Volt D.C. only. NOTE: Not externally ignition protected.
3" heavy duty ring. Hot dipped galvanized for long life.
Hot-dipped galvanized for long life. Includes enough screws and washers to attach 3 PlayStar marine dock floats to frames. Contains twelve 3/8" x 2" lag screws and twelve 3/8" flat washers.
Hot-dipped galvanized for long life. Includes fasteners for use with PlayStar's Framing Kits, Hinge Kits, and Pipe Sleeves. Contains twelve 3/8"-16 x 3" carriage bolts, twelve 3/8" flat washers, twelve 3/8" lock washers, and twelve 3/8" nuts.
Fits most engines with side water inlets. Flushes away sand, silt, salt, and alkali. Prevents clogging and corrosion, extending the engine life. Installs in seconds without tools.
All round light. Rubber storage clips hold pole when not in use. Nickel plated brass finish washer suitable for up to #8 fastener.
Securely attaches stationary and roll in docks. Hot dipped galvanized for long life.
Pre-drilled to accommodate four #6 screws. Durable chrome plated brass ring is small enough to fit on most hatches, cabinets and drawers.
Hot dipped galvanized for long life. Prevents twisting and bending.
Fuel connector, male for OMC engines. Brass construction and 1/4" NPT thread.
Fits 1 5/8" and 1 7/8" diameter pipe.
Inflatable. For use on boats. Protects all sizes of boats.
Recommended for boats up to 12 meters/39.4 feet. Non-flammable, no CFC'S. Good for over 80 blasts. Ideal for marine safety sporting events.
Easily, and securely, anchors dock pipe to bottom. One piece, heavy-duty cast iron construction securely fastens to pipe with single stainless steel nut and bolt. Hot dipped galvanized for long life. Use with No.PS1080 Commercial Grade pipe sleeve. For use with 1-5/8" O.D. and 1-7/8" O.D. dock pipe.
Hot dipped galvanized for long life. Securely ties frame together.